Wire Die Recutting Services

Like-new performance from your worn single crystal and polycrystalline diamond dies, at a lower cost than replacing them.

Spool of drawn wire

Fort Wayne Wire Die recutting restores worn single crystal diamond (SCD) and polycrystalline diamond (PCD) dies to near-new condition. We use the same technology, craftsmanship and quality controls as in original die manufacture, so die geometry and bearing lengths stay within your specifications.

Recutting extends die life and helps you maintain wire quality while controlling cost.

Download the spec sheet (PDF) Request a Quote

Improve operating efficiency

Analysis

We inspect every die we receive to assess wear and recutting factors. The inspection can reveal abnormal wear or usage that may be hurting your productivity.

Process

Stringent quality controls and the original manufacturing technology keep the accuracy of die geometry and bearing lengths within your requirements.

Options

Choose from our three-tier quality standard to balance cost, performance and the number of recuts you get from each die.

Recut quality definitions

A higher quality level may require removing more material from the die, which reduces the number of recuts possible. We offer evaluation services to help you choose the level that fits the material drawn, the application and the wire surface finish you need.

X quality

The recut die may have cracks anywhere in the drawing area, but it must be able to draw round wire without clicks.

XX quality

The recut die may have small cracks or imperfections in the reduction area, but not in the bearing.

XXX quality

The recut die must have no imperfections in the drawing area of the die.

Diagrams of die wear, die nomenclature and recut die profiles are in the spec sheet.

Elongation set recutting

We also recut matched elongation sets to original manufactured quality standards. Each set is recut to your requirements using proprietary die calculation software that matches die elongation to your machine. Every die is performance tested, certified and documented to an elongation tolerance of ±0.5%, marked with the set number and packaged as a set for easy installation.

Ordering information

To assure prompt service, please include the following on your order.

Recut dies

  1. First and second requested hole size
  2. Hole size tolerance
  3. Reduction angle
  4. Bearing length
  5. Wire material
  6. Recut quality level

Recut elongation sets

  1. Hole size
  2. Hole size tolerance
  3. Reduction angle
  4. Bearing length
  5. Wire material
  6. Recut quality level
  7. Wire drawing machine manufacturer and model number
  8. Transmission diagram
  9. Number of die positions in the machine
  10. % elongation between each die
  11. Diameter of supply wire
  12. Finish die diameter and tolerance
  13. Die material type
  14. Stamping instructions

Standard die stamping marks the front of the die and, for elongation sets, the back with the set number. See the spec sheet for the stamping layout.

Suggested microscope viewing ranges

Hole size (inch)Hole size (mm)Magnification
.002 and smaller0.05 and smaller120–160X
.00201–.0040.0501–0.1090–120X
.00401–.0100.101–0.2560–90X
.0101–.0900.2501–2.3030–45X
.0901 and larger2.301 and larger10–20X

Request a Quote Contact Us